Interested to Buy Any Domain ? << Click Here >> for more details...
which will glow brighter?bulb 1 (110v,100w) and bulb 2
(230v.200w) series connection
- 6 Answers
- 8713 Views
- EnPower India, I also Faced
- E-Mail Answers
Answer Posted / zeeshan akbar
bulb 1 required 0.909 Ampere,
bulb 2 required 0.869 Ampere to full glow.
If we connect both in series.
same current will flow in both bulbs
bulb 2 required low current then bulb 1, so bulb 2 will
flow beter.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to calculate the distance relay faulty zone?pls explain?
why does make gain margin and phase margin on same plot.?
what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
DERIVE AN EXPREION FOR MAXIMUM POER TRANSMISSION, WHAT ARE ITS APPLICATIONS.
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
what are the factors to be considered while design the breaker either HT or LT??
How much should be the load percentage for 15kva Inverter and Iinut & I output load with Calculations
armature winding of dc machine produce alternating emf then it convert in to dc by using commutator.But only we consider armature resistance why don't we consider inductive reactane effect?
What is meant by celling voltage & current in excitor ?
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
