Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of wave trap in an electrical substation?
- 2 Answers
- 15570 Views
- I also Faced
- E-Mail Answers
Answer Posted / pandiyarajan
It is connected series with transmission line. its used for communication purpose. It will block the high frequency signal (communication signal) and allow the low frequency (power)
| Is This Answer Correct ? | 29 Yes | 2 No |
Post New Answer View All Answers
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
When are the directional relays used?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
How could a garment factory benefit from renewable energy
how does it help for selection of a transformer.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What is dynamo?How it works and what is the function of dynamo in a DG.
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
electrical
Why using synchronising methed in DG's sets?
Write masons gain formula.
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
