Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ghanshyam singh
we don't use wave trap in feeder, it's used in the GSS for creating connection between two GSS's.
actually we use the same power line for sending our voice and power both.
thus wave trapper is used to modulate our voice to the frequency of our power, i.e. 50 hz.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
Explain the advantages and disadvantages of hydropower plant?
What are the three major categories of error?
What is mean by hot and cold loop testing? What is the difference between them?
Define resonant peak?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
what exactly commisioning work does in electrical site work... LT side?..
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
what is the meaning of 5% droop or 7% droop in AVR?
Why in ESP Positive earthed
