What is the meaning of STAR POINT? Why this important in CT and VT?
- 2 Answers
- 10676 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / krushna ch sahoo
the meeting point at which all the phase
terminals are neutralised called as star
point
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
What is expention fastener (Fan)
When MICC cables used ?
What is inverse definite minimum time lag relay? Where is it use?
what happens to the supply voltage if there is any change in frequency?
what is different between phase and netural
how u measure/calculate renge of capacitor,capacitor has no any rating tag.what is the theory of measure of capacitons.
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
hi friends if you have any 400KV Substation Erection and installations Drgs please send to me.My email id:kandi.suresh441@gmail.com
Write the force balance equation of ideal spring element.
What are the types of instrument transformer?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
why the check zone and main zone are used for Busbar Protn. scheem?
how we can calculate the efficiency of a diesel generator ?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
