In our domestic single phase line if you don't have a ground
connection (earthing)how will you separately use earth in a
specific power supply board.
Answer Posted / k.prakashchandra
Have your own earthing system and run the earth wire from it .
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
For high frequency application we use which transformer?
what is the principle of operation of tungstun bulb ??
substation+ plc system
what happen ehen synchronisation is done at below rated speed
List the power rating of any 5 important electrical appliances used in houses.
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
Who are the manufacturer for Nitrogen based Fire Protectio/explosion prevention for Oil Filled Transformers? India and international both?
What is the previous name of Cox's Bazar
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
what is a pilot wiring and whys that called a pilot wiers
Why let through energy not considered for ACB breaker while cable sizing?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What are the different types of controllers?