Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of compensation in designing a transmission
line
- 1 Answers
- 3712 Views
- Genco, I also Faced
- E-Mail Answers
Answer Posted / nandhakumar.v
in transmission lines there may be more losses in the
transmitting conductor and also current may be lagging in
the user end...to avoid this compensation is need in
transmission
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
how to build a network which step down 415v to 1v rms
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
why in the three pin plug all 3 pins are cutted ?
Explain the role of a car driver as one of a feedback mechanism.
how to store the thunder power?
Is vtg is controlled by the resistor? if else how much?
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
Why a tesa lamp is glow between two phase?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
how can we select the appropriate VCB ?
What are the different types of LT Cables?
