Interested to Buy Any Domain ? << Click Here >> for more details...
differance b|w ground, neutral&earth
- 11 Answers
- 25951 Views
- Bhel, SKH Metals, I also Faced
- E-Mail Answers
Answer Posted / ajit
Neutral is used to close the ckt. with phase voltage and earthing is used to collect leakage voltage from the body and release it to the ground for human safety.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Dear sir, iam completed iti ncvt electrician 2000-2002 & diploma electrical eng completed 2008-2010 distance education in rvd university, still i got B licences only but my working company want C licences, how to i get c licencese pls reply me iam in critical situation thank you karthick 9841637803
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
What does quality factor depend on in resonance?
What are the advantages and disadvantages of the dc motors?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
how we sesign the transformer give some specifion regarding design of transformers
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how choose conductor&depending upon load
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
What is the estimated total hydropower potential of india?
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
