What is the Procedure for selecting a Cable, Breaker and
Transformer for particular load.
- 3 Answers
- 5284 Views
- I also Faced
- E-Mail Answers
Answer Posted / guptar48
Amps rating is correct for selecting cable. but my question
is that what is the equition to calculation of cable or
wire size as per load requirement.Exam: total load is 4Kw
then which size cable will be required?
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is gross error?
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
How dia computation perfomed in cold rolling mills .
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
How to convert a two phase power into a three phase power in induction machine?
what is rocking arrangement in arc heating
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
impliment (AB)`+C to transistor representation
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
How to test IR testing & magnetic balance test
how to select electronic timer(Star-Delta) setting for diff. rating motors
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
What is stepper motor?
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
