what are the values to be accepted on 3 core 185sq mm for
11000volts on insulation resistance between conductors and
between conductors and earthed?
Answer Posted / k.prakashchandra
Normally we take 2M ohm /KV as sufficient IR
Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
v/f drive basic princeple
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
1.What will be stored in online ups EPROM IC?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
for 750 kw LT load what will be the ht kva
Is there any question in the name of Static Switch in UPS??
Explain the difference between verilog task and verilog function?
What are IR values and what it should be for coil and for insulator
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
300m long and 30kw inductive loade 3phase supply how many size cable required
What is inverse definite minimum time lag relay? Where is it use?
Define sensitivity?
IN 1000kva transformer where the oil and winding temperature sensors is connected
what is the relative size of single and three phase?
what is upper impedance and lower impedance of a distance relay