Interested to Buy Any Domain ? << Click Here >> for more details...
GIVE THE TEMPERATURE RANGE OF PLATIUM RESISTANCE THERMOMETER.
- 7 Answers
- 8522 Views
- DVC, I also Faced
- E-Mail Answers
Answer Posted / bhag singh
390.48 ohms
| Is This Answer Correct ? | 0 Yes | 10 No |
Post New Answer View All Answers
how to calibrate 0- 150 psi presure gauge by dead weght tester
Specify for Cables - Flame Retardant and Fire Resistant?
What is the diffrence between ff tx and non ff tx
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
what is the responsibility of an instrument commissioning supervisor
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
How we calculate orifice plat size???
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
Why even multiple power supplu r used in instrumentation system?
what are the steps I have to deal with?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
i am having information technology branh ....... can i prepare for psu exam
How to interfacing microcontroller with a DC motor
line up procedure for dp type flow transmitter?
