Interested to Buy Any Domain ? << Click Here >> for more details...
When batteries of different voltages are connected in
parallel what happends
- 4 Answers
- 7326 Views
- ID, Infosys, I also Faced
- E-Mail Answers
Answer Posted / ravi shanker
After sometime the voltage of all the battries are same because the batteries which has less voltage draw current from high voltage batteries. In this way low voltage batteries chages itself and high voltage batteries dischage upto that level where voltage level is equal.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
What are the differences between microprocessor and micro controller?
Explain what is associate law?
Sir, I am Mrunalini studying btech 2nd year in ECE.i want to know the information about group2.how to prepare for group2? about coaching centres in hyd.what are the postings in group2? in which year i should take coaching?plz send me the informaion to my mail id.
What Are The Advantages Of Spread Spectrum?
Explain different types of feedback.
Why thyristors are not preferred for inverters?
What are the key inputs and factors considered to plan the number of SGSN/GGSN if you have to set up a Greenfield network?
What is modulation? Explain in detail.
How is the inverter circuit classified based on commutation circuitry?
I am a fresher and i have done testing course from orbit institute hyd.can any1 say me whether it is necessary to do project in testing.if it is that which is best institute in hyd.can you please inform me if there is any job 4 freshers.thanxs
What do you mean by electronics? How is it different from electrical?
i am going to visa second time i was rejected on 15-07-08 and on 14-08-08 i am attending visa again with another university.so what would be the good answer if they asks that why you have changed the university?
What is graticule?
How to get KWH,Voltage & current datas from 2KVA hybrid inverter to my computer
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
