A 230V, 60W bulb when connected to 230v supply what current
and power will consume, if same bulb is connected to 200v
what purrent and power will consume?
Answer Posted / sanjay
while 60W bulb connected to 230v it will consume 0.261A.if
same bulb connected to 200v it will consume 0.3A
Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
what is the difference between pvc & fiber glass cables
What are the reasons for the parallel operation of transformers?
whate is the meaning of balance/unbalance,in stabilizers type
hello if any one have papers vof hpcl or sail, plz send me
Can clean earth cable be considered as low current cable
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
What is the difference between PLC and Embeded system
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
What is the feedback in the control system?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
Why do we avoid electrical conduits in floors at apartments?
why dc is used in control circuits for MV & LV switchgeras instead of ac
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.