Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashish gupta
HMI(Human Machine Interface) is a system that shows the
plant parameters to human operator, operator only can see
the parameters and cannot change them.
Where as SCADA is a system which shows the parameters and
also logs the data and alarms and through this data also can
be changed.
| Is This Answer Correct ? | 5 Yes | 7 No |
Post New Answer View All Answers
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
whats the abbreviation of IOP? is it instrument of power or input open problem?
Why do we have earthing cable in branch cable and shield in the same cable?
2. What is ultrasonic flowmeter?
how many types of preheaters are in cement industry & what r they can any body explain?
How does temperature bath work? How does coil gets heated only by applying some current?
pls give me presant awerness quistion and answer in my emailid.
Specify for Cables - Flame Retardant and Fire Resistant?
What are the uses of orifice plates?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
What is the difference between modbus,fieldbus & profibus
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
