Interested to Buy Any Domain ? << Click Here >> for more details...
why armature is placed in stator but not in rotor in
synchronous generator ?
- 2 Answers
- 3975 Views
- Student, I also Faced
- E-Mail Answers
Answer Posted / n.j
Armature is not placed in rotor because of high cost of
insulation required to evacuate the power from the rotating
side.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Could you measure voltage in series?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
State the frequency for rc phase shift oscillator?
DG SET BLOCK DIGRAM
What is the feedback in the control system?
How can we checked Killo Watts of Motor & Alternator?
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
what is the safety points of vaccum circuit breaker.
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
is it possible to test of bus bar in high rise building without completed full floor ?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
What is MS-EXCELL?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
