Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
To allow for stray voltages,PT errors and voltage
differece due to unbalanced loads
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is primary and backup protection?
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
My load is 1635 KW. & current pf is 0.884, I have to improve it for 0.99.Please suggest what KVAR value is needed?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
Which type of questions well asked. ?
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
What is the purpose of stablization resistor in high impedance bus bar protection
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
