what is the meaning of bus bar, in electrical panels.
Answer Posted / harithejas
Busbr is an electrical conductor material (copper or
aluminium), suitably sized to carry specified currents both
thermal and short circuit for a defined time, supported on
insulators or surrounded by insulation materials, used to
make common connections between many circuits or
interconnect incoming power supply and outgoing feeders.
The shape of busbar material can be any, but videly seen
are rectangular, circular tubes, wires etc.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
what is earth resistance? how to measured? and give values at power station and mcc area?
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
What type of DC motor would you see for a lift?
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
What current flows in the transformer primary when its secondary is open?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is the difference between circuit breaker and isolator
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
Why use in ht motore
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
how to compute kvar in substation feeder to improve power factor and sending voltage
how can i change the rotation of the AC single phase induction motor and show me by diagram