Interested to Buy Any Domain ? << Click Here >> for more details...
if d gen is 50kw,load is 60 kw,hw d gen ll supply d
remaining power?
- 3 Answers
- 5445 Views
- NHPC, I also Faced
- E-Mail Answers
Answer Posted / bhaskar santra
You can overload the Generator but the generator will get
heated up and may get damaged.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to calculate fuse rating for a motor
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
what curve and rateing would you use for a three phase 0.75kw motor?
I need bhel electrical test pattern & paper
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
Explain about technical and non technical losses in distribution system?
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
explain single phase series motor
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
Define ohm’s law for a.c (alternating current)?
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
