Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / volkan
It is used for to isolate the system after the secondary
side from the system before the primary side.
These kind of transformers also called as isolation
transformers.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what is the voltages using in movie theaters??? why ??why not other??
What is Auto Mains Failure Panel & Auto Synchronizing Panel
the winding of Generator and Motor is star or in delta ? and why
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
How to calculate energy stored in an inductance?
What is boucholz relay and the significance of it in to the trformer?
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
what is efficient motors and how it is different from normal induction motors
Which motor connection is preferable star-delta or delta-star?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
before synchronizing an alternator,power factor is leading ,why?
