how can we convert 48V dc into 12 V dc? Any standard device
for it??
- 2 Answers
- 4379 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
potential divider or DC/DC converter (PSU- Power supply
unit)
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
which network topology offers the greatest level of tolerance?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
What should be setting for alarm,tripping and cooling fan on for power transformer's oil temp. and winding temp. indicator?
