Interested to Buy Any Domain ? << Click Here >> for more details...
What are the disadvantages of Human-Machine Interface (HMI)?
atleast 3.
- 1 Answers
- 19789 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
it is precise only for modelling and simulations
data can be damaged if elecrtronic component is damaged
troubleshooting is appllicable for one specific constraint at
a time
interfacing is expensive
seperate cost should be alotted for hmi during modelling
| Is This Answer Correct ? | 19 Yes | 11 No |
Post New Answer View All Answers
how to turbine speed measurement?
What is difference between ESD and PLC please Explain me clearly.
What is super thermocoupal?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
why orfice is not used for main steam flow calculation
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
What is the procedure of calibration of Load cell?
what is the different between deflection type measurement and null type measurement in RTD?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
With N nodes and B branches what will have a network ???
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
can we copy the software from a transmitter using hht(hart 275) ?
What are the uses of orifice plates?
