If I want to lab 16 mm dia. bar with 20 mm dia bar with 40D
lap length which dia.should I consider for lapping
- 12 Answers
- 50632 Views
- I also Faced
- E-Mail Answers
Answer Posted / vimalsekar
Laplength varies with repest to the standards we follow
viz., BIS , MORTH and IRC. As per BIS, for 50 % lap (lap
given to alternate bars) with different reinforcement
sizes, lap length shall be 50 D of the smaller size
reinforcement.
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
Define the various stages of the project planning process in construction.
Critical Path Method is...
What you understand by building codes?
Analyze the rate for 1st class brick work in superstructure with 1:6 cement sand mortar. Consider 1000 cu.ft quantity and work out the rate per cu.ft
how to calculate cost of raw materials of a building for 1000 sqft & also consolidated cost of labour in a 1000 sqft building
is there any influence of water(used for mixing of concrete) on a weight of harndend concrete.
Describe Briefly The Various Methods Of Concrete Curing?
Mention different types of roof systems?
Explain the Strength of brick?
What is the worlds largest concrete dam?
significance of specific surface area of particles?
in plate load test what is the thickness of plate 20mm 5mm 50mm none
Time required for curing of wall tiles before fixing
Are cruise ships built for the transatlantic run?
What things you need to take care of before building a kitchen island?
