Interested to Buy Any Domain ? << Click Here >> for more details...
I am pujita completed Electronics and Instrumentation
Engineering.As a fresher i am going to attend the
interviews.Could anybody guide the topics/questions covered
mostly in interviews.
- 11 Answers
- 23910 Views
- I also Faced
- E-Mail Answers
Answer Posted / jageshwar rathore
hi,
recently I attended an int.view firstly they ask about
introduction,my favorite sub.& ask related to it,also they
ask me how to measure pressure, displacement,
flow,temperature & basic principle of such devices.so you
must focus on the control instrument and you should read the
book of A.K.shauni & D.S.Kumar.read only basics.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Calibration of controller (pneumatic)
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what is RTV function in in process control?
What is the use of temperature compensation?
Operational amplifiers
How u measure the massflow in orifice flow measurement techniques
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
how to check earthing,what is minum ohms for proper earthing
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
please send me the inteview questions in IOCL
explain key exchanges in all security modes WPA,WPA2,TLS?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
