how can we test the polarity of a 3-phase transformer?
Answer Posted / mark from the philippines
we can use a Transfromer Turn Ratiometer(TTR) instrument to
identify the polarity of the three phase transformer. say
for wye-delta configuration at H-X format of transformer
leads, we can read the following:
H1H0/X1X2; H2H3/X2X3; and, H3H1/X3X1.
Note that Ho stands for neutral since connection is in
Y-config.
The slash (/) indicates the test lead connections, two per
sides. Good polarity indicates a positive sign value(+),
otherwise, negative(-) which means there exists a wrong
connection.
Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
What is slope...? Explain slope 1 and slope 2...?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
does any one know where we can purchase insulation oil for high voltage oil filled cables
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
HI SIR, AM PREPARING FOR RRB FOR SECTION ENGINEER POST. PLZ SEND ME THE PREVIOUS QUESTION PAPERS AND HELP ME. I HAVE NO ENOUGH TIME MY EXAM DATE IS 22ND JUNE.... MY EMAIL ID IS nalla.amarnath@gmail.com
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
what is the use of permanent magnet generator in exciter
Explain the different regions in frequency response?
Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
How to confirm the Phase shifting Transformer VECTOR GROUP relation , as below ZNy11.45d10.45-ZNYy0.15d11.15
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.