Why are transmission lines multiples of 11? Is it because of
some historic reason ? Or is there a scientific base to it?
Answer Posted / k.prakashchandra
Historical reason. Electric bulbs were first used in America
and they were of 100V DC. When AC was introduced, the same
bulbs were made to work on 110 V AC applying the form factor.
Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
How many turns are there in primary winding? (In Transformer)
What is meant by Load Encroachment in OHL Feeder Protection?
What is class ab operation?
why the NGR (neutral grounding resistor) always OFF during DG off?
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
WTA used cb?
how a.c. genarator control power factor when its conected to grid supply by incrising or decresing excitation voltage.
PIU how does work?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
tell me about roaster switch .& what is the function in transmission & distribution?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
Define the term Capacitance and Inductance?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.