Why are transmission lines multiples of 11? Is it because of
some historic reason ? Or is there a scientific base to it?
- 5 Answers
- 5215 Views
- I also Faced
- E-Mail Answers
Answer Posted / amit bamal
It is becoz of economic reason.
| Is This Answer Correct ? | 0 Yes | 9 No |
Post New Answer View All Answers
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
can some one clearly explain why -48 volt DC use in telecom site????
What types of question are done for diploma students in aptitude test
How many types of colling system it trformers?
What is the name of the winding to which supply is given?
How many methods use the load flow solution?
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
What kind of maintenance is conducted for Transformer
how to calculate slip ring induction motor stator and rotor currents??
How many types of instrument cables are there?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
