Interested to Buy Any Domain ? << Click Here >> for more details...
Why are transmission lines multiples of 11? Is it because of
some historic reason ? Or is there a scientific base to it?
- 5 Answers
- 6708 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagarjuna
because of form factor always we go for sinusoidal in
practical and rms vaue required so the value is 1.11,and one
more reason as per the indian standards (BIU) .if we use
13kv and one may use 23kv , so that the equipment for
designing is very difficult so we go for standard notation
as per BIU
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What is lc oscillator?
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
what is the IS foe lightning arrester?
Please tell me the power flow from pmg to main rotor of an alternator (Including AVR unit)?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
What is time response of the control system?
what are your career plans upon completion of the programme and the relevance of recity generation to your professional development?
WHY RATING OF VCB NOT LESS THAN 630A
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
what is meant by skew width in machines?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
