Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / apoorv
It depends on whether the field winding of the dc motor is connected in series or in shunt with the armature winding.If it is connected in series,the motor will rotate since the torque,which varies as the product of the armature and field current is always positive.Thus,a positive average torque causes the motor to rotate,however the pulsating nature may cause the commutator segments and brushes to wear out.
Thus only small sized dc motors may be used with ac supply.
Read more: http://wiki.answers.com/Q/What_will_happen_if_you_give_AC_supply_to_a_DC_motor#ixzz1PFQibbRO
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?
why does the magnetic balance tests at transformer?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
suri transmission
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
Difference between control junction box (cjb) and power junction box(pjb)?
the winding of Generator and Motor is star or in delta ? and why
can any one suggest paper presentation topies for electrical engg?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
How to check the cable fault / hv test of transformer cable.
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
What is resistance reading of earth copper rod with grid and without grid?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
