Answer Posted / akki
Simple as always the dc motor in most cases would not even
start but if it does the load capacity would be like
pathetic
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
why asa method ZPF method is more accurate than ASA method?
Ac generato how produce power I need for camplet defination
how to check three phase motor torque value?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
what is high and low cut off voltage of BB and DG at SPS????????
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
How to design harmonic filter at the project stage without nowing the harmonics levels
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
Meaning of ingrace protection for motor.for ex IPXY
Details about Flux Compensated magnetic Amplifer starter for motors
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
how much flux density of CRNO core
how can we select the appropriate VCB ?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
standard earthing rating for power line..