Answer Posted / rakesh verma
INDUCTANSE BLOCK TO DC SIGNAL & PASS TO AC SIGNAL IN
CIRCUIT. INDUCTANSE USE IN GANARATE MAGNETIC FLUX.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
advantage and disadvantage of team work?
I want definition for ABT Meter (Availability Based tariff) ?
how is the incoming cable size calculated for a given current rating of a panel??
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
How will polarity test of Dy5 Transformer ?
why chock were used in old tubelights but are not newest tubelights?
What is difference between start imitation and start interlock for 3 phase motor protection ?
magnetizer priciple
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
What are chief characteristics of state-space method and its techniques ?
write a program that prints prime numbers from 1-20 in digonal form
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
