What is "Bending moment"? Demonstrate on theory not for
formula.
Answer Posted / dinesh.rk
> simple.. the moment (created by force x distance) the
tends to bend the structural/ any other member.
2 cases are - positive (sagging)
- negative (hogging)/
this can be explained by:
consider a rcc(singly reinforced) beam- in which the
bottom of center span (+ve) and top of support (-ve)
section are reinforced to taking care of BM/
Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
Describe a time when you anticipated potential problems and developed Preventive measures
What is zoning permit?
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
How to check slab shuttering level.? Or check list for slab ?
What is the difference between Fe 500, Fe 500 D and Fe 515.
Whats the standard thickness of 20'/30' wide rcc service road and what will be the estimated cost per cubit feet
Formula for calculation volume of essentric footing
afe or not
What is the difference between a wood shake and wood shingles?
Coverage of 25mm.thick ratio of 1:4 cement mortar?
Which is the indian standard code of line out. ? How much tolerance fot 1 mt lenght? Its challenge....
could u tell me how to used deform stell bar in reinforce concret?i wanna know the general using in the site!
Why should pumping be not used in case of concreting works?
what is E
what is relation between SPT N value and driving piles after conducting a soil test?