a node has the ip address 138.50.10.7 and 138.50.10.9. But
it is transmitting data from node1 to node2 only. The reason
may be
a)a node cannot have more than one address
b)class A should have second octet different
c)classB " " " " "
d)a,b,c
- 1 Answers
- 9391 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul dutta
a)
| Is This Answer Correct ? | 17 Yes | 0 No |
Post New Answer View All Answers
Discuss the different factors affecting congestion control algorithms. ?
We can use Office Communication server instead of any dialer?
What was the reason for selecting a speed of 155.52 Mbps in the original ATM standard ?
What is Brouter (Bridge Router)
when I issue the "show ip route bgp" command, I see my routes being learned via ospf and bgp. How can I verify on the nx-os which one will always be used and which one is a backup?
1. What ports does FTP traffic travel over? 2. What ports does mail traffic utilize? 3. What ports do HTTP and HTTPS use? 4. Why is NTP required in an NFS network? 5. Name some common mal software on the server side 6. What is CPAN? How do you access it? 7. What is PEAR? 8. What advantages does mod_perl have over a perl CGI? 9. What is required to do SSL in Apache 1.x? 10. What is Tcl? 11. What is a servlet engine/container? 12. What is BIND? 13. Name the steps to setup a slave zone in BIND 14. Name the steps to setup a primary zone in BIND 15. What commands would you use under Solaris or Linux to modify/view an LDAP tree?
Explain pure-ALOHA and slotted- ALOHA systems. Give the expression for throughout for each,clearly explaining the various terms.
What do you understand by the term ‘structured cabling’. State the main rules that should be used when installing a cable. 31. Show that maximum cabling area for LAN for horizontal cabling runs is approximately 200m.
Differentiate between SMTP and SNMP
What is the advantage of Ring network ? Compare it with ethernet
The physical layer service is a non-confirmed service. Assume that some bits of data are lost during transmission over physical media, which layer will detect the loss and take some remedial measures. Explain any one method clearly depicting how this operation is performed.
Can you name all the physical layers in networking?
Why is a data link layer switch preferred over a hub ?
A binary signal is sent over a 3-khz channel whose signal-to-noise ratio is 20 db.Calculate the maximum achievable data rate ?
Define Explore a world of satellite solutions?
