Interested to Buy Any Domain ? << Click Here >> for more details...
If a fixed gear having 200 teeth is in mesh with another
gear having 50 teeth.The two gear are connected by an
arm.What will be the number of turn made by the smaller gear
for one revolution of arm about the center of bigger gear?
Any effort is appreciable witha proper logic..
- 8 Answers
- 16223 Views
- I also Faced
- E-Mail Answers
Answer Posted / mfs
Since rotation of bigger gear is not mentioned, consider it
stationary. Then, for one revolution of arm, the smaller
gear rotates 4 times around the bigger gear.
200/50=4.
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
can anyone guide me me for engineering service commission exam?
Why did you choose this career?
how buoyancy force is realte with convection?
Explain what does 0.125 inch stand for in 0.125 inch npt thread?
Why rockets using liquid hydrogen have higher specific impulse compared to liquid hydrocarbon ?
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
Name the grade of forged steel use for manufacturing of master connecting rod and why to prefer that grade.
How do you determine what suction pressure should be in r22 air conditioning compressors suction line?
give me an example of time when u something u tried to accomplish and failed.
What are the advantages of a centrifugal pump over a reciprocating pump?
how to calculate the size and weight of induced draft axial fan impeller
At 50 Centigrade (Fuel oil) what is its cast?
Where can i see model papers for NLC graduate engineer test and RRB section engineer test
What is vane diagram in centrifugal pump?
hi i m Divyen . i have completed 10+3 in diploma in mechanical Engineering. so can i apply for student visa for canada?
