Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashish mahadik
1.Which is the inlet side.
2.Material of construction
3.bore size in mm
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
How to fix back the valve actuator stem
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
protection relay watchdog contact operation?
What is the reason PT speed not incresed in gas turbine?
What are the type of bonnets in the control valves?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
how to measure oxygen which methods are using?
How will you test a transistor with a multimeter?
what deference between panel earth and systemearth
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
