What is the fullform of IPS in substaion using Aluminium
Tubes
Answer Posted / gopalakrishnan.s
THIS IS A TUBE TO AVOID THE SHARP EDGES IN BUS BAR DUE TO
THAT SKIN EFFECT WAS MINIMIZED
| Is This Answer Correct ? | 6 Yes | 7 No |
Post New Answer View All Answers
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
what is doid
what do you mean by plant earthing system.
what is the use of piston rings in the engine used for a generator...........
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
how to design the heater in temperature control unit to heat 50KL of water?
difference between main metering kiosk and check metering kiosk
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
does any one know where we can purchase insulation oil for high voltage oil filled cables
HOW TO CALCULATE EARTHING SIZING?
what is the illumination level required for child play area?
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
What is the difference between security constraint unit commitment and security constraint optimal power flow?
how can we say that stator magnetic field rotates with synchronous speed?can we derive?