Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rushikesh s gaddpawar
Three Element loop control is close loop system. In this
system mainly use in power plant that means it use 1.main
steam flow 2.feed water flow 3.drum level.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
draw shematic diagram of c/v positioner(smart type)?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Gas equation
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
Isometric drawings are generated during _________________ phase of a project
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
how can use ram
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
Turbidity analyzer working principle ?
