difference between fleming's left hand rule and RHR briefly.
- 3 Answers
- 10382 Views
- I also Faced
- E-Mail Answers
Answer Posted / satendra
The right hand rule is used for the generator. In generator
the current is produced so right hand rule tell us about
the current.
While the Left hand rule is used in the Motor. We
calculate the force on the conductor wires so the left hand
rule tells us about the Direction of the Force.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Which type of DG need Netral Earthing?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
how to select rating of HT Panel
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
If increased the frequency up to 1000 then what changes shows in voltage?
Define corner frequency?
please explain to me how to calculate current,voltage,resistance with formula??
How do we calculate transformer oil in liter from the rating of the transformer.
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
Why do not we prefer non conventional sources of energy to conventional sources?
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
