Interested to Buy Any Domain ? << Click Here >> for more details...
different between twostroke engine foure stroke engine
- 3 Answers
- 8218 Views
- I also Faced
- E-Mail Answers
Answer Posted / manjunath
1.in 4stroke the cycle in completed in 4strokes of the
piston..or in 2rev of crank shaft...
a.in 2stroke the cycle is completed in 2strokes of the
piston..or in 1rev of crank shaft...
2.in 4stroke spark ignition..
b.in 2stroke compression ignition...
3.power produced for same size of engine is small...
c.----"---------"----------"------------ is more....
4.4stroke contains valve mechanisms....
d.2stroke---"----- ports ----"-----...
5.lesser wear and tear in 4stroke.......
e.greater -------"----- in 2stroke.....
6. thermal effi is 25%........
f. --------"------ 30-36%.....
7.4stroke works on ooto cycle....
g.2stroke works on diesel cycle......
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is a pressure cap in the radiator?
What is sae? Mention the importance of sae to the automobile domain.
How bhp is measured?
Explain terminal engine meltdown?
For the second gear in a synchromesh system, the drive transfer will be through a) U1, U2, C, F2, and splines b) U1, U2, C, F1, and splines c) U1, U3, D, F3, and splines d) U1, U4, U5, E, F2, and splines
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
The permanent reduction provided by the final drive in heavy vehicle is a) 4:1 b) 6:1 c) 8:1 d) 10:1
What is engine efficiency?
Explain Rankine cycle.
The main advantage of single plate clutch over cone clutch is a) Easier gear changing b) Less binding of contact surfaces c) Less pedal movement d) all of the above
The main function of transmission is a) To provide means to vary the torque ratio between the engine and the road wheels b) To provide neutral position c) To provide means to back the car d) all of the above
Tell me the formula of heat loss in a pipe.
Why oil is mixed with coolant and what are causes of this?
What is the Diesel consumption of 1000 KVA rating DG set at full load?
What is dtsi?
