Interested to Buy Any Domain ? << Click Here >> for more details...
What is Backlash in gears.when it will be harmfull?
- 3 Answers
- 8778 Views
- Bajaj, I also Faced
- E-Mail Answers
Answer Posted / mechanicallyloaded
Backlash is the gap that is to be kept between two
meshing tooths of two gears.i.e. it is the gap between the
tooth thickness and tooth space and it is kept to prevent
the jamming of the gears when they are in running condition
because on running the gears will heat up and due to this
the metal expands so the tooth requires some space to
expand which is provided by back lash in the gears.
otherwise the gears will cut each other and there
is a lot of wear and tear and the gears may also get jammed
and seize to rotate.
If you can visualize two gears then you will find that they
have a play between them while in meshing condition this
play is backlash which is generally between 0.1mm to 0.3mm
depending on the material of the gears.
If there is more backlash between gears then while running
the gear tooths will try to slip up of the meshing gears
tooth and there will be more wear and tear as the gears are
hot while running and hot material is softer than its cold
counterpart. There will also be more noise between the
gears if they have more backlash.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What are the factors that can affect the factor of safety selection?
Explain the procedure in staring a F.O. purifier
List two effects of manganese in plain carbon steels?
What is a magnetic valve of refrigeration system?
what is the responsibility of assistant manager in welding in goa shipyrad company?
what type of question has been asked at schwing stetter
Why and what cause of leak fuel oil in high pressure pipe of main engine?
please send jindal steel and power model question papers
What is the difference between tube and pipe?
What are the causes of liner high temperature?
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
What is the difference between stalling and surging in rotary compressions ?
Q. what @the interview exact Q&A is it correct
What is the gas constant r for air?
Which type of question u have asked to the fresher
