how will you find out the fuse failure by remote operation?
Answer Posted / n.pandiarajan
connect a high resistance and a indication lamp across the
fuse.
If fuse is normal then the current flows through the load
now because of high resistance the indication lamp doesn't
glow.
In case of fuse failure the current flows through the high
resistance path to complete the circuit now the indication
lamp starts glows.
Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
Whether the vacuum contactor requires Short circuit protection?If No,why?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
How to calculate Temp from Resister from PT100 equation,
What conditions are required for transformer to operate at low frequencies ?
Whether power factor should be high or low? Why?
What is the use of bundle conductors?
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
What does ampere turns shows?
can i use 2000/5A Clamp meter to measure HT cable
what is the responsibility of C license holder in industry?