Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the
energy loss =?
Voltage drop = ?
Conductor resistance at 20 degree C = ?
Temprature convertion Factor at 50 degree c = ?
on ACSR DOG Condutor at following data.
distance = 4.8 kM
Load = 2980 kWh
Size of Conductor = 6/ 0.186
Volt = 11 kV.
- 1 Answers
- 5252 Views
- Pakistan Atomic Energy Commission PAEC, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You have given the load in Kwh.Dog conductor resistance at
20' C is 0.281 ohm/km
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
Why sometime AVR and sometime Booster coil is used in Alternator? what is the diferance between AVR & Booster coil due to which they are selected
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
The loads are connected with phase and ground then why current flow as the loads ?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
Why use in ht motore
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
What are test signals and their significance?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Why a tesa lamp is glow between two phase?
Whether power factor should be high or low? Why?
which network topology offers the greatest level of tolerance?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
What is evaporator & condencer & compressor
