Interested to Buy Any Domain ? << Click Here >> for more details...
Why we transmit the power at the voltage in the multiple of
11 or 1.1 like 11kv, 22kv, 66kv, 132kv...... some one told
me that it is due to fomr factor 1.1 of sine wave. its fine
but while transforming we can choose any voltage, so why
only multiple of 1.1 there also.......? plz tell me.
- 7 Answers
- 8010 Views
- I also Faced
- E-Mail Answers
Answer Posted / lokeshraj
Its fine that it is due to form factor.. but my question
was while transforming the supply in step up or strp down
why dont we choose anther voltage not the multiple of 1.1
there... we can choose aby ratio for that.... plz tell me...
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to calculate micom relay earth falt time and current sertting
why the protection turbo generators is most complex?
What is The Resistance Formula
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
What are the three constants associated with a steady state error?
what is the difference between pvc & fiber glass cables
How to measure current and voltage in an ELV circuit
What is the formula to calculate the rating of power cable for three phase current.
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
which is better to use svc or synchronous condenser why ?
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
What is open delta Xformer? It's adavntages & Use?
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
