Thermocouple is a transducer but rtd is not transducer why?
Both taking heat as a input and giving mv
- 7 Answers
- 14278 Views
- I also Faced
- E-Mail Answers
Answer Posted / ulaganathan
in GENERAL CONSIDER AN THERMOCOUPLE WHENEVER IM
GIVING HEAT(PHYSICAL PARAMETER) THERE EXIST GENERATION
OF POTENTIAL RESISTANCE(ELECTRICAL PARAMETER) BY
SEEBECK EFFECT.IT IS AN SECONDARY IT IS AN SECONDARY
ONE
BUT INCASE OF AN RTD FOR THE CHANGE IN PHYSICAL
PARAMETER THAT IS HEAT IS CONVERTED TO CHANGE IN
DISPLACEMENT OF COIL (AGAIN AN PHYSICAL PARAMETER
MEASURESED. HENCE ITS AN SENSOR.IT IS AN PRIMARY ONE
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
How earthing can be checked????
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How to work togather like sov,limit switch,proxy switch and booster in xv
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
How can measure flow in oil line?which type of transmitter is generally used?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
How to find out the current of two motors having same power consumption but different RPM?
Why ac supply load cell is used? Can we use the dc supply load cell?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
flow transmitter formula?
