Interested to Buy Any Domain ? << Click Here >> for more details...
Why we transmit the power at the voltage in the multiple of
11 or 1.1 like 11kv, 22kv, 66kv, 132kv...... some one told
me that it is due to fomr factor 1.1 of sine wave. its fine
but while transforming we can choose any voltage, so why
only multiple of 1.1 there also.......? plz tell me.
- 7 Answers
- 8009 Views
- I also Faced
- E-Mail Answers
Answer Posted / sharan dilip
it is due to form factor.
FORM FACTOR is the ratio of rms value to average value (
voltage or current)
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
How many VSC based HVDC are there in India and the world
Please explain me abt PQ diagaram in the power sector.
How i can calculate current of cable according to ares?
what are the available sizes of pin type terminal lugs in the market today?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
orifice sizing how done, checking & selection
what is the difference between b c d curves on mcb
What is minimum phase system?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
How to calculate loses in transformer of 160 KVA ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
