Answer Posted / jignesh patel(abb)
The philosophy for modbus and profibus is same.....the
difference is
1.modbus you can go up to 1200m only in the case of profibus
you can go up to 2-5 km.
2.In modbus the speed will be 125kbs where profibus it will
be 1.5 mbs to 12mbs.
3.In modbus you can connect maximum 32 devices for RS485
where in Profibus you can go upto 127devies without repeater.
| Is This Answer Correct ? | 18 Yes | 4 No |
Post New Answer View All Answers
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Why boiler chimney area oxyden sensor fixing?
How is PH sensor works ?
How oil line flow measured?eplain about instruments used and working principle?
How is flow measured in square root?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How to Calibrate Level Switch in field
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
draw shematic diagram of c/v positioner(smart type)?
Can anyone send most commonly asked interview question in Oil & Gas industry
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
What is limitation of the ht.of the displacer of a level trol?