what is the difference between bus-coupler and bus-riser
Answer Posted / ahmed
Act as connector between MDBs and SMDBs by the blg in box
(tap off )
Used in high rating currents with low voltage drop it
contain from cupper tabs separated by insulation for
connector (RYPNE) There is many types and rating of bus
bare as per sit condition
Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
wish of these transformer uses oil?
which pump used in STP
What is steady state response?
If not into production, how far did you follow the design and why did not you see it into production?
Why it is possible to use PWM with a STATCOM and not with a conventional TCR based SVC
What is meant by reset level of the relay?
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
What kinds of decision are made about CT from it's Knee point(voltage & current)?
Why you want to join non technical field when you are an engineer?
explain wiring system
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
how to test the electrical panel.ht lt mcc pcc.
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...