Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
There are 3 windings marked as a1 a2,b1 b2,and c1 c2.In star
a2 ,b2 and c2 are shorted and supply will be given to a1, b1
and c1.In delta a1 and c2, a2 and b1, and b2 and c1 are
shorted and supply will be given to 3 common points
| Is This Answer Correct ? | 37 Yes | 8 No |
Post New Answer View All Answers
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
What is sensitivity of a measurement?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
what are the types of electromagnetic forces developed in practical transformer?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
how to maintain frenquncy with syncronising sub-station for distribution
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
what is the difference between droop mode and ischnorous mode in thermal powerplant?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
by what factor the starting current is used when comparing star and delta connection for motor starting?
The moisture in air will condense at
substation+ plc system
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
