A vertical plate and a horizontal plate are suspended in an
open room. Both are heated to the same temperature. Which one
will cool first?
Answer Posted / sujit singh
here since cooling will take place by convection. if the temp of plate is higher than room temp .. heat will flow from plate to room.. thus causing it to cool. heat transfer by convection depends on surface area.. and here surface area exposed to room atmosphere is same in both case... so both will cool at same rate.there is natural convection as we are not using any device to cause the motion of air over plate. so no question of forced convection.
Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
How can I weld A234 WPB and WPB P11 fitting? Any special heat treatment required? What happen if I weld both?
what are the activities to be done after a steam turbine trips?
Hello there, Im a Mechanical Engineer. I passed out in 2010 and have worked for 6 months in the Middle East as a Trainee Engineer. Im now in India and due to appear for an Interview for a firm in the Middle East. The post is of an Automobile Engineer. Im kinda nervous as to what to prepare for the interview. The training which I got was in different areas ranging from technical to managerial aspects. What I mean to say is that that was more of a crash training, where I couldn't stick to one section alone. The interview which Im attending is more of a technical one. What I would like to know, how and what I should be preparing? I have two weeks for the preparation. Should I go through the normal automobile aspects or everything in random. PS: I have excellent communication skills, the one area in which I'm very confident.
When repacking a valve the rings of packing should be oriented so that the packing ends are installed ____________.
What is the use of gravity disc?
What are the causes of damage of diesel engine exhaust Valve?
which type feect in generator and turbine in reverse power protection
What is control volume system?
What are SAE ratings?
ball pen is writtingg on paper
why we do not megger to motor under system is very high vaccum condition. and what is the tempreture of vaccum conditon
What are the rules that must be kept in mind while designing castings?
What are hydraulic and pneumatic machines?
Which pollutant is major greenhouse gas and what is its effect ?
Horse power of i.c. Engines can be expressed as rac rating, sae rating, or din rating. To which countries these standards belong ?