If the load of transformer is getting more than its
rating,,,than how to overcome this problem? Suppose thee
rating of transformer is 315kva and the load is going
beyond than the rating say around load: 352kva...
Than how can we solve this problem without deducting the
load.
Answer Posted / prakash kumar
actually this is not because the transformers are rated to
work at the rated KVA levels above their Kva levels the
winding will undergo heated temperature and the above
condition is not possible this will result in burning of the
windings
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
why we r not earthed Control cable of C.T. terminals
how much flux density of CRNO core
State any two nuclear power stations in India, with their generating capacity.
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
what is the difference between electrical and electronic choke?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
which protection function should measure RMS value of current&DFT value of current?
what is mean by Digital Logic Meter (DLM)
why we need to us lenz's law for synchornous motor
battery capacity use of made?
How could a garment factory benefit from renewable energy
What is proportional controller?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?