in single phase circuit if i connect a heater between phase
and neutral, then what will be the current path? phase to
neutral or neutral to phase.
Answer Posted / syed ali raza naqvi
according to theory the path of current is phase to neutral
but a practically the current path is neutral to phase.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between verilog task and verilog function?
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
How energy is generated in hydroelectric power plant?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
how a flip flop can be used as a latch?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
what will happen if frequency is below 50 hz?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
what are the installation procedure of high voltage power transformer,CT,CB&PT?
What is nichols chart?
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
What is the cut-off rate?
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
I am applying for NTPC examination.Can we please provide previous paper to my mail prasad.chintala108340@gmail.com