Why breakers not synchronized when the synchroscope is going
in the anticlockwise direction?
Answer Posted / yogesh
If the synchronoscope reads in anticlockwise direction
means the generator is running too slow. To close the
Breaker the incoming Generator frequency should be higher
than the existing Generator. Than only the incoming
Generator will take the load as soon as the Breaker gets
synchronised
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
how to calculate fuse rating for a motor
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
What is turn ratio of a transformer?
how to carried out DAR test in 11 KV Alternator ?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
sugest any typical project ?
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
What are the raitings of Mcb,mccb and Acb in detail ??
what is the practical application of full adder circuit?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
Define delay time.
explain Density
Showing results for capital, machinery, stock,wages, carriage in words, salaries, factory rent, repairs, fuel and power, buildings, debtors, sales, purchases, creditors, return outwords, return inwords, drawings, discount allowed, discount receivable, office expenses, bills payable, bills receivable, cash in hand, cash at bank, office rent comes under debit or credit